Test:handler:status:index - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:HANDler:STATus:INDex

Syntax :TEST:HANDler:STATus:INDex {ON|OFF|1|0}
Description This command sets the Handler Index value for test purpose and can be used to
check/troubleshoot the Test pin signal of Handler interface. (No Query)
NOTE When
controlled/read by :TEST:HAND:xxxx commands. After completing the test,
:TEST:HANDler:MODE
according to the actual measurement result.
Parameters
ON
OFF
Related commands :TEST:HANDler:STATus:ALARm on page 286
:TEST:HANDler:STATus:NC on page 289
:TEST:HANDler:STATus:OVLD on page 290
:TEST:HANDler:STATus:RDYTrig on page 291
Equivalent key No equivalent key is available on the front panel.
sequence
288
:TEST:HANDler:MODE is set to ON, the interface pin signal value can be
should set to OFF so that handler interface pin signal is generated
Sets Handler index signal to ON.
Sets Handler index signal to OFF.
Description
Chapter 10