Table of Contents
Advertisement
Command Reference
E4981A SCPI Commands
:DATA:POINts:BUF1
Syntax
:DATA:POINts:BUF1 <numeric>
:DATA:POINts:BUF1?
Description
Specifies the size of data buffer 1 in number of measurements. Executing this command
returns the pointer to the specified data buffer (the location to feed measurement data) back
to the start.
NOTE
The functionality of this command is same as
Parameters
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
MAX or MIN can be used to specify the parameters.
Query response
{numeric}<newline><^END>
Related commands
:DATA:FEED:BUF1 on page 194
:DATA:FEED:CONTrol[:STATe] on page 198
Equivalent key
No equivalent key is available on the front panel.
sequence
200
:DATA:POINts[:DATA]
Number of measurements for the data buffer specified with BUF1
1 to 200
200
1
with value of BUF1.
<numeric>
Chapter 10
Advertisement
Table of Contents
