Table of Contents
Advertisement
:FORMat:STATus:EXTension
:FORMat:STATus:EXTension {ON|OFF|1|0}
Syntax
:FORMat:STATus:EXTension?
Description
This command enables/disables the status extension reporting for Contact check failure.
If the status reported (numeric1) from *TRG,
LowC or No Contact), then
source of Contact Check failure. The return value of status determines the source of contact
check failure and are as follows:
•
+8: Threshold1 Failure
•
+16: Threshold2 Failure
•
+128: Signal Level Check failure when LVL COMP = ON and Contact Check = ON.
Parameter
ON or 1
OFF or 0
Query response
{1|0}<newline><^END>
Related commands
*TRG on page 169
:FETCh? on page 217
:READ? on page 226
[:SENSe][:FIMPedance]:CONTact1:VERify[:STATe] on page 256
Equivalent key
No equivalent key is available on the front panel.
Chapter 10
:FETCh?
:FORMat:STATus:EXTension
Description
Enables the extended reporting of Contact Check Failure.
Disables the extended reporting of Contact Check Failure.
Command Reference
E4981A SCPI Commands
and
:READ?
is 2 (Detection of
can be enabled to find the
221
Advertisement
Table of Contents
