Table of Contents
Advertisement
•
When specifying STAN3 as parameter 1:
Description
Range
Initial value
Unit
*1.Use the
In any case, if the specified parameter is out of the allowable setup range, the minimum
value (if the lower limit of the range is not reached) or the maximum value (if the upper
limit of the range is exceeded) is set.
Query response
{numeric 1},{numeric 2}<newline><^END>
Related commands
[:SENSe]:CORRection:OPEN[:STATe] on page 244
[:SENSe]:CORRection:SHORt[:STATe] on page 245
[:SENSe]:CORRection:LOAD[:STATe] on page 238
[:SENSe]:CORRection:MULTiple[:STATe] on page 241
[:SENSe]:CORRection:MULTiple:CHANnel on page 239
[:SENSe]:CORRection:CKIT:STAN1:FORMat on page 229
[:SENSe]:CORRection:CKIT:STAN2:FORMat on page 230
[:SENSe]:CORRection:CKIT:STAN3:FORMat on page 232
:FORMat[:DATA] on page 222
Equivalent key
[
Meas Setup
sequence
[
Meas Setup
[
Meas Setup
Chapter 10
Parameter 2: <numeric 1>
Value of the primary parameter
-999.999 to 999.999
100E-9
F (farad)
[:SENSe]:CORRection:CKIT:STAN3:FORMat
of parameter.
] - CORRECTION - OPEN - A|B
] - CORRECTION - SHORT- A|B
] - CORRECTION - LOAD- A|B
Command Reference
E4981A SCPI Commands
Parameter 3: <numeric 2>
Value of the secondary
*1
.
*1
parameter
.
-99.9999E9 to 99.9999E9
0
Depends on the type of parameter.
command to specify the type
237
Advertisement
Table of Contents
