Fetch - Keysight Technologies E4981A Programming Manual

:FETCh?

:FETCh?
Syntax
Description Reads out the measurement result. The target measurement to read out depends on the state
of the E4981A. (Query Only).
• During measurement:
• Other states:
If overload or no contact is detected (that is, the measurement status is 1), the measured
values of the primary parameter and secondary parameter are 9.9E37 and the comparator
sorting result is 11.
The transfer format of data read out with this command conforms to the setup made with
the :FORMat[:DATA]
NOTE If the comparator function is disabled (OFF has been specified with the
:CALCulate1:COMParator[:STATe]
{numeric2}, and {numeric3}, are read out.
{numeric 1}, {numeric 2}, {numeric 3}, and {numeric 4} are as follows:
{numeric 1}: Measurement status (one of the integers between 0 and 3 listed below)
{numeric 2}: Measured value of the primary parameter
{numeric 3}: Measured value of the secondary parameter
{numeric 4}: Comparator sorting result (an integer between 0 and 11 listed below)
Query response {numeric 1},{numeric 2},{numeric 3},{numeric 4}<newline><^END>
Related commands :READ? on page 226
*TRG on page 169
:FORMat[:DATA] on page 222
:CALCulate1:COMParator[:STATe] on page 187
Chapter 10
Waits for end of the measurement and then reads out its result.
Reads out the result of the immediately preceding measurement.
command. (Query only)
0: No error
1: Detection of overload (OVLD)
2: Detection of Low C or No Contact (See
page 221)
0: Sorted into OUT_OF_BINS.
1: Sorted into BIN1.
2: Sorted into BIN2.
3: Sorted into BIN3.
4: Sorted into BIN4.
5: Sorted into BIN5.
6: Sorted into BIN6.
7: Sorted into BIN7.
8: Sorted into BIN8.
9: Sorted into BIN9.
10: Sorted into AUX_BIN.
11: OVLD (Overload) or NC (No contact) [sorting not possible]
E4981A SCPI Commands
command), only three data items, {numeric1},
:FORMat:STATus:EXTension on
Command Reference
217