Setting Up Measurement Conditions and Display
Saving/Recalling Instrument Setup State (save/recall function)
Saving/Recalling Instrument Setup State (save/recall
function)
You can save/recall up to 20 instrument settings into/from the built-in nonvolatile memory
(Flash memory, 0 through 9) and external USB memory (10 through 19).
NOTE
The ninth instrument setting corresponds to Auto Recall.
Auto recall is not executed when power is ON, by pressing the
For information on the instrument setups you can save/recall, refer to Operation Manual,
Appendix C "Initial Setting".
Saving instrument setup state
To save the instrument setup state, use the following command.
•
•
Recalling saved instrument setup state
To recall the saved instrument setup state, use the following command.
•
•
50
*SAV on page 167
:MMEMory:STORe:STATe[:REGister] on page 225
*RCL on page 166
:MMEMory:LOAD:STATe[:REGister] on page 225
key.
[Preset]
Chapter 3