Test:handler:status:ovld - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:HANDler:STATus:OVLD

Syntax :TEST:HANDler:STATus:OVLD {ON|OFF|1|0}
Description This command sets the Handler Overload signal status for test purpose and can be used to
check/troubleshoot the Test pin signal of Handler interface. (No Query)
NOTE When
controlled/read by :TEST:HAND:xxxx commands. After completing the test,
:TEST:HANDler:MODE
according to the actual measurement result.
Parameters
ON
OFF
Related commands :TEST:HANDler:STATus:ALARm on page 286
:TEST:HANDler:STATus:INDex on page 288
:TEST:HANDler:STATus:NC on page 289
:TEST:HANDler:STATus:RDYTrig on page 291
Equivalent key No equivalent key is available on the front panel.
sequence
290
:TEST:HANDler:MODE is set to ON, the interface pin signal value can be
should set to OFF so that handler interface pin signal is generated
Sets Handler Overload signal status to ON.
Sets Handler Overload signal status to OFF.
Description
Chapter 10