Test:handler:mode - Keysight Technologies E4981A Programming Manual

:TEST:HANDler:MODE

:TEST:HANDler:MODE {ON|OFF|1|0}
Syntax
:TEST:HANDler:MODE?
Description This command sets the Handler Comparator Function value for test purpose and can be
used to check/troubleshoot the Test pin signal of Handler interface.
NOTE When
controlled/read by :TEST:HAND:xxxx commands. After completing the test,
:TEST:HANDler:MODE
according to the actual measurement result.
Parameters
ON or 1
OFF or 0 (initial value)
Query response {1|0}<newline><^END>
Related commands :TEST:HANDler:BIN on page 283
:TEST:HANDler:COMP on page 284
:TEST:HANDler:KEYLock? on page 284
Equivalent key No equivalent key is available on the front panel.
sequence
Chapter 10
:TEST:HANDler:MODE is set to ON, the interface pin signal value can be
should set to OFF so that handler interface pin signal is generated
Sets Handler mode to ON.
Sets Handler mode to OFF.
Command Reference
E4981A SCPI Commands
Description
285