[:Sense]:Correction:collect:load:range:auto - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

[:SENSe]:CORRection:COLLect:LOAD:RANGe:AUTO

Syntax [:SENSe]:CORRection:COLLect:LOAD:RANGe:AUTO {ON|OFF|1|0}
[:SENSe]:CORRection:COLLect:LOAD:RANGe:AUTO?
Description Sets on/off of auto ranging when the load correction is executed. When this function is set
at off, the range which is selected by
the load correction.
For auto ranging when a measurement is executed, use
[:SENSe][:FIMPedance]:RANGe:AUTO
NOTE The functionality of this command is same as
[:SENSe]:CORRection:COLLect:LOAD:RANGe:AUTO.
Parameter
ON or 1 (initial
setting)
OFF or 0
Query response {1|0}<newline><^END>
Related Commands [:SENSe]:CORRection:COLLect[:ACQuire] on page 233
[:SENSe][:FIMPedance]:RANGe[:UPPer] on page 262
:SYSTem:PRESet on page 279
Equivalent key [
Meas Setup
sequence
234
[:SENSe][:FIMPedance]:RANGe[:UPPer]
Set auto ranging at on. The load correction is performed with auto
ranging. (AUTO).
Set auto ranging at off. The load correction is performed at the
range which is selected by
"[:SENSe][:FIMPedance]:RANGe[:UPPer]"
] - CORRECTION - LOAD RNG- AUTO|FIX
Description
is used for
.
Chapter 10