Table of Contents
Advertisement
Command Reference
E4981A SCPI Commands
:TRIGger:SEQ2:DELay
Syntax
:TRIGger:SEQ2:DELay <numeric>[mS|S]
:TRIGger:SEQ2:DELay?
Description
Specifies the waiting time between when a trigger is inputted and when the measurement
starts (trigger delay time).
Parameters
Description
Range
Initial value
Unit
Resolution
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
NOTE
A fraction below the resolution is rounded off. MAX or MIN can be used to specify the
parameters.
Query response
{numeric}<newline><^END>
Equivalent key
[
Meas Setup
sequence
300
Trigger delay time
0 to 1
0
s (second)
100u
] - TRIG DLY
<numeric>
Chapter 10
Advertisement
Table of Contents
