Test:scanner:index - Keysight Technologies E4981A Programming Manual

Command Reference
E4981A SCPI Commands

:TEST:SCANner:INDex

Syntax :TEST:SCANner:INDex {ON|OFF|1|0}
Description This command sets the Scanner Index signal for test purpose and can be used to
check/troubleshoot the Test pin signal of Scanner interface. (No Query)
NOTE When
controlled/read by :TEST:SCAN:xxxx commands. After completing the test,
:TEST:SCANner:MODE
according to the actual measurement result.
Parameters
ON
OFF
Related commands :TEST:SCANner:CH? on page 292
:TEST:SCANner:EOM on page 293
:TEST:SCANner:MODE on page 295
:TEST:SCANner:TRIGger? on page 296
:TEST:SCANner:VALid? on page 296
Equivalent key No equivalent key is available on the front panel.
sequence
294
:TEST:SCANner:MODE is set to ON, the interface pin signal value can be
should set to OFF so that scanner interface pin signal is generated
Sets Scanner Index signal status to ON.
Sets Scanner Index status to OFF.
Description
Chapter 10