Trigger[:Seq1]:Source - Keysight Technologies E4981A Programming Manual

:TRIGger[:SEQ1]:SOURce

:TRIGger[:SEQ1]:SOURce {INTernal|MANual|EXTernal|BUS}
Syntax
:TRIGger[:SEQ1]:SOURce?
Description Selects the trigger mode from the following four types.
Internal
Manual
External
BUS
Parameters
INTernal (initial value)
MANual
EXTernal
BUS
Query response {INT|MAN|EXT|BUS}<newline><^END>
Related commands *TRG on page 169
:READ? on page 226
Equivalent key [
Meas Setup
sequence
NOTE You cannot set the trigger mode to GPIB/LAN/USB (Bus) using the front panel keys.
Chapter 10
Configures the instrument to use its internal trigger source so that is it
automatically and continuously triggered.
Configures the instrument to be triggered when you press the
key on the front panel.
Configures the instrument to be triggered when a trigger signal is
inputted through the Ext TRIG terminal or handler/scanner interface.
Configures the instrument to be triggered when the
executed through GPIB/LAN/USB.
Specifies Internal.
Specifies Manual.
Specifies External.
Specifies GPIB/USB/LAN (Bus).
] - TRIG - INT|MAN|EXT|BUS
Command Reference
E4981A SCPI Commands
*TRG command is
Description
[Trig]
299