E4981A Scpi Commands; Abort; Calibration:cable:correction:clear - Keysight Technologies E4981A Programming Manual

Command Reference

E4981A SCPI Commands

E4981A SCPI Commands
This section describes the SCPI commands of the E4981A.

:ABORt

Syntax :ABORt
Description Resets the trigger system and places the trigger sequence in the idle state.
If the trigger system is set to start up successively (ON is specified with the
:INITiate:CONTinuous
transition to the idle state.
For details on the trigger system, refer to
Related commands :INITiate[:IMMediate] on page 224
:INITiate:CONTinuous on page 224
Equivalent key No equivalent key is available on the front panel.
sequence

:CALibration:CABLe:CORRection:CLEar

Syntax :CALibration:CABLe:CORRection:CLEar <numeric>
Description Clears the cable correction data. (No query)
Parameters
Description
Range
Related commands :CALibration:CABLe:CORRection:COLLect[:ACQuire]:LOAD on page 171
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:OPEN on page 171
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:REFerence on page 172
:CALibration:CABLe:CORRection:SAVE on page 172
:CALibration:CABLe:CORRection:STATe? on page 173
Equivalent key [
System
sequence
170
command), the trigger system starts up immediately after the
Cable Length (in meters)
1 or 2
] - CABLE CORR - 1m|2m - CLEAR
"Trigger system" on page
<numeric>
60. (No query)
Chapter 10