Calibration:cable:correction:state - Keysight Technologies E4981A Programming Manual

:CALibration:CABLe:CORRection:STATe?

:CALibration:CABLe:CORRection:STATe? <numeric>
Syntax
Description Gets cable correction ON/OFF. (Query Only)
Parameters
Description
Range
NOTE The value of this command is not changed with
changed with Factory Default reset (available only through Front Panel).
Query Response {1|0}<newline><^END>
Related commands :CALibration:CABLe:CORRection:CLEar on page 170
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:LOAD on page 171
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:OPEN on page 171
:CALibration:CABLe:CORRection:COLLect[:ACQuire]:REFerence on page 172
:CALibration:CABLe:CORRection:SAVE on page 172
Equivalent key No equivalent key is available on the front panel.
sequence
Chapter 10
<numeric>
Cable Length (in meters)
1or 2
*RST
Command Reference
E4981A SCPI Commands
and :SYSTem:PRESet and is only
173