Test:handler:bin - Keysight Technologies E4981A Programming Manual

:TEST:HANDler:BIN

:TEST:HANDler:BIN <numeric>
Syntax
Description This command sets the Handler Bin No for test purpose and can be used to
check/troubleshoot the Test pin signal of Handler interface. (No query)
NOTE When
controlled/read by: TEST:HAND:xxxx commands. After completing the test,
:TEST:HANDler:MODE
according to the actual measurement result.
Parameters
Numeric Value
0
1-9
10
11
Related Commands :TEST:HANDler:COMP on page 284
:TEST:HANDler:KEYLock? on page 284
:TEST:HANDler:MODE on page 285
Equivalent key No equivalent key is available on the front panel.
sequence
Chapter 10
:TEST:HANDler:MODE is set to ON, the interface pin signal value can be
should set to OFF so that handler interface pin signal is generated
Out of Bins
BIN 1 to 9
AUX BIN
All Off
Command Reference
E4981A SCPI Commands
Description
283