Table of Contents
Advertisement
MX10003 3D Universal Edge Router Quick Start
Tools Required to Prepare the MX10003 Router for Installation
Step 2: Install the MX10003 Chassis in the Rack
6
Figure 3: Airflow Through the MX10003 Router
Blank panels to cover any slots not occupied by a component
Mounting brackets, supplied with the router
Eight screws for securing the mounting brackets to the chassis, supplied with the router
Phillips (+) screwdriver, number 2, not supplied
Four mounting screws, supplied with the router
Cable management bracket, supplied with the router
Two screws for securing the cable management bracket, supplied with the router
To install the router in a rack or cabinet:
Position the router in front of the rack or cabinet.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and to a
2.
site ESD point.
Using a Phillips (+) number 2 screwdriver, remove the screw on each side of the chassis
3.
that holds the rear-mounting brackets, and slide the brackets out of the chassis (see
Figure 4 on page
7). Keep the brackets safely to be used in later stage.
The rear-mounting brackets on each side of the chassis are movable. You can adjust
the brackets according to the depth of the rack. However, the front-mounting brackets
on each side of the chassis are fixed to the chassis.
Copyright © 2017, Juniper Networks, Inc.
Advertisement
Table of Contents
