Setting The User Default Parameter Set - Siemens SINAMICS V20 Operating Instructions Manual

5.6.3.16

Setting the user default parameter set

Functionality
The user default parameter set allows a modified set of defaults, different to the factory
defaults, to be stored. Following a parameter reset these modified default values would be
used. An additional factory reset mode would be required to erase the user default values
and restore the converter to factory default parameter set.
Creating the user default parameter set
1. Parameterize the converter as required.
2. Set P0971 = 21, and the current converter state is now stored as the user default.
Modifying the user default parameter set
1. Return the converter to the default state by setting P0010 = 30 and P0970 = 1. The
converter is now in the user default state if configured, else factory default state.
2. Parameterize the converter as required.
3. Set P0971 = 21 to store current state as the user default.
Setting parameters
Parameter Function
P0010 Commissioning parameter This parameter filters parameters so that only those related to a particular func-
P0970 Factory reset
P0971 Transfer data from RAM
to EEPROM
For information about restoring the converter to factory defaults, refer to Section "Restoring
to defaults (Page 138)".
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
Setting
tional group are selected.
= 30: Factory setting
This parameter resets all parameters to their user default/factory default values.
= 1: Parameter reset to user defaults if stored else factory defaults
= 21: Parameter reset to factory defaults deleting user defaults if stored
This parameter transfers values from RAM to EEPROM.
= 1: Start transfer
= 21: Start transfer and store parameter changes as user default values
Commissioning via the built-in BOP
It must be set to 30 in order to store or delete user defaults.
5.6 Function commissioning
131