Siemens SINAMICS V20 Operating Instructions Manual page 240

Parameter list
8.2 Parameter list
Parameter Function
P0881[0...2] BI: Quick stop source 1
Allows quick stop source 1 command to be selected using BICO. The signal is expected to be active low
(default setting P0886 = 2).
Setting: See P0810
P0882[0...2] BI: Quick stop source 2
Allows quick stop source 2 command to be selected using BICO. The signal is expected to be active low
(default setting P0886 = 2).
Setting: See P0810
P0883[0...2] BI: Quick stop override
Allows quick stop override command source to be selected using BICO. The signal is expected to be
active high.
Setting: See P0810
P0886[0...2] Quick stop input type
Control Word for selecting the quick stop input type.
0
1
2
3
4
P0927 Parameter changeable
via specified interfaces
Specifies the interfaces which can be used to change parameters. This parameter allows the user to easi-
ly protect the converter from unauthorized modification of parameters.
Annotation: P0927 is not password protected.
Bit
00
01
02
03
04
Example: Default: All bits are set.
The default setting allows parameters to be changed via any interface.
r0944 Total number of mes-
sages
Displays the total number of messages available.
238
Range
0 - 4294967295
0 - 4294967295
0 - 4294967295
0 - 4
Quick stop not selected
Quick stop input active high
Quick stop input active low
Quick stop input positive edge triggered
Quick stop input negative edge triggered
0 - 31
Signal name
Not used
BOP (including built-in BOP and external BOP)
USS on RS232
USS on RS485
Script terminal on RS485
-
Factory Can be Scaling
default changed
1 T -
1 T -
0 T -
2 T -
31 U, T -
1 signal
Yes
Yes
Yes
Yes
Yes
- - -
Operating Instructions, 10/2019, A5E34559884-012
Data Data Acc.
set type Level
CDS U32 3
CDS U32 3
CDS U32 3
CDS U16 3
- U16 2
0 signal
No
No
No
No
No
- U16 3
SINAMICS V20 Converter