Parameter List - Siemens SINAMICS V20 Operating Instructions Manual

Parameter list

8.2 Parameter list
8.2 Parameter list
Parameter Function
r0002 Converter state
Displays actual converter state.
0
1
2
3
4
5
6
P0003 User access level
Defines user access level to parameter sets.
0
1
2
3
4
P0004 Parameter filter
Filters parameters according to functionality to enable a more focused approach to commissioning.
0
2
3
5
7
8
10
12
13
19
20
21
22
24
P0005 Parameter display
selection
Selects default display parameter (converter display).
Example: The converter displays the value of the parameter selected here by default.
Notice: If you have set P0005 to a non-zero value which represents an actual parameter number, then the con-
verter displays the value of the selected parameter as the default display value; if you have set P0005 to 0
or a non-zero value which does not represent an actual parameter number, then the default display re-
mains unchanged.
198
Range Factory
default
- -
Commissioning mode (P0010 ≠ 0)
Converter ready
Converter fault active
Converter starting (visible only while pre-charging DC link)
Converter running
Stopping (ramping down)
Converter inhibited
0 - 4 1
User defined parameter list - see P0013 for details on use
Standard: Allows access into most frequently used parameters
Extended: Allows extended access, for example, to converter I/O functions
Expert: For expert use only
Service: Only for use by authorized service, password protected
0 - 24 0
All parameters
Converter
Motor
Technology application/units
Commands, binary I/O
Analog input and analog output
Setpoint channel/RFG
Converter features
Motor control
Motor identification
Communication
Warnings/faults/monitoring
Technology controller
List of modified parameters
0 - 9580 0
Can be Scaling Data set Data
changed
- - -
U, T - -
U, T - -
C, U, T - -
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
Acc.
type Level
U16 2
U16 1
U16 1
U16 2