Siemens SINAMICS V20 Operating Instructions Manual page 216

Parameter list
8.2 Parameter list
Parameter Function
P0292 Converter temperature
warning [°C]
Defines the temperature difference (in °C) between the overtemperature trip threshold (F4) and the warn-
ing threshold (A504) of the converter. The trip threshold is stored internally by the converter and cannot be
changed by the user.
P0294 Converter I
Defines the [%] value at which warning A505 (converter I
Converter I
The I t calculation value is deemed = 100 % when this maximum tolerable period is reached.
2
Dependency:
The output current of the converter has been reduced.
•
The value of I
•
Note: P0294 = 100 % corresponds to stationary nominal load.
P0295 Converter fan off delay time
[s]
Defines converter fan switch-off delay time in seconds after converter has stopped.
Note: Setting to 0, converter fan will switch off when the converter stops, that means no delay.
P0301[0...2] Easy motor data, rated
motor power [kW]
Rated motor power from the rating plate. No other data is necessary. If this parameter is used, the rest of
the motor data are then estimated by the firmware.
Dependency: Changeable only when P0010 = 1 (quick commissioning).
Caution: This functionality is only valid with 50 Hz supply, star configuration on 4-pole motors. You must set this
parameter to zero if you desire to set the other motor data.
P0304[0...2] Rated motor voltage [V]
Nominal motor voltage from rating plate.
Dependency: Changeable only when P0010 = 1 (quick commissioning).
Default value is depending on converter type and its rating data.
Caution: The input of rating plate data must correspond with the wiring of the motor (star/delta). This means, if delta
wiring is used for the motor, delta rating plate data has to be entered.
214
Range
0 - 25
t warning [%] 10.0 - 100.0
2
t calculation is used to determine a maximum tolerable period for converter overload.
2
t does not exceed 100 %.
2
0 - 3600
0 - 2000
10 - 2000
Factory Can be Scaling
default changed
5 U, T -
95.0 U, T -
t) is generated.
2
0 U, T -
0 C(1) -
400 C(1) -
Operating Instructions, 10/2019, A5E34559884-012
Data Data Acc.
set type Level
- U16 3
- Float 3
- U16 3
DDS Float 1
DDS U16 1
SINAMICS V20 Converter