Siemens SINAMICS V20 Operating Instructions Manual page 300

Parameter list
8.2 Parameter list
Parameter Function
Note: See P2201
P2216[0...2] Fixed PID setpoint mode
Fixed frequencies for PID setpoint can be selected in two different modes. P2216 defines the mode.
1
2
P2220[0...2] BI: Fixed PID setpoint
select bit 0
Defines command source of fixed PID setpoint selection bit 0.
P2221[0...2] BI: Fixed PID setpoint
select bit 1
Defines command source of fixed PID setpoint selection bit 1.
P2222[0...2] BI: Fixed PID setpoint
select bit 2
Defines command source of fixed PID setpoint selection bit 2.
P2223[0...2] BI: Fixed PID setpoint
select bit 3
Defines command source of fixed PID setpoint selection bit 3.
r2224 CO: Actual fixed PID
setpoint [%]
Displays total output of PID fixed setpoint selection.
Note: r2224 = 100 % corresponds to 4000 hex.
r2225.0 BO: PID fixed frequency
status
Displays the status of PID fixed frequencies.
Bit
00
P2231[0...2] PID-MOP mode
PID-MOP mode specification
Bit
00
01
Note: Defines the operation mode of the motorized potentiometer. See P2240.
P2232 Inhibit reverse direction of
PID-MOP
Inhibits reverse setpoint selection of the PID-MOP.
0
1
Note: Setting 0 enables a change of motor direction using the motor potentiometer setpoint (increase/decrease
frequency).
P2235[0...2] BI: Enable PID-MOP (UP-
cmd)
Defines source of UP command.
298
Range
1 - 2
Direct selection
Binary selection
0 - 4294967295
0 - 4294967295
0 - 4294967295
0 - 4294967295
-
-
Signal name
Status of FF
0 - 3
Signal name
Setpoint store active
No On-state for MOP necessary
0 - 1
Reverse direction is allowed
Reverse direction inhibited
0 - 4294967295
Factory Can be Scaling
default changed
1 T -
722.3 T -
722.4 T -
722.5 T -
722.6 T -
- - -
- - -
1 signal
Yes
0 U, T -
1 signal
Yes
Yes
1 T -
0 T -
Operating Instructions, 10/2019, A5E34559884-012
Data Data Acc.
set type Level
DDS U16 2
CDS U32 3
CDS U32 3
CDS U32 3
CDS U32 3
- Float 2
- U16 3
0 signal
No
DDS U16 2
0 signal
No
No
- U16 2
CDS U32 3
SINAMICS V20 Converter