Siemens SINAMICS V20 Operating Instructions Manual page 61

Digit-by-digit editing can be performed on parameter numbers, parameter indexes, or
parameter values. This editing method is best suited when large changes are required to
parameter numbers, indexes, or values. For information about the converter menu structure,
refer to Section "Converter menu structure (Page 55)".
● In any edit or scroll mode, digit-by-digit editing is entered by a long press (> 2 s) on
● The digit-by-digit editing always starts with the rightmost digit.
● Each digit is selected in turn by pressing
● Pressing
● Pressing
being edited.
● Pressing
● If more digits are required to the left, then these must be added by scrolling the existing
leftmost digit above 9 to add more digits to the left.
● Pressing
Example 1:
Editing parameter numbers
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
once moves the cursor to the rightmost digit of the current item.
twice in succession exits the digit-by-digit mode without changing the item
on a digit when there are no further digits to the left saves the value.
or for over two seconds enters fast digit scrolling.
Example 2:
Editing parameter indices
If a parameter is an array, edit indices
as illustrated below:
Commissioning via the built-in BOP
5.1 The built-in Basic Operator Panel (BOP)
.
Example 3:
Editing parameter values
.
59