Siemens SINAMICS V20 Operating Instructions Manual page 363

6. Set P0804 (select clone file). This step is necessary only when the card contains the data
files that you do not desire to be overwritten.
P0804 = 0 (default): file name is clone00.bin
P0804 = 1: file name is clone01.bin
...
P0804 = 99: file name is clone99.bin
7. Set P0802 (transfer data from converter to card) = 2.
The converter displays "8 8 8 8 8" during transfer and the LED is lit up orange and flashes at
1 Hz. After a successful transfer, both P0010 and P0802 are automatically reset to 0. If any
faults occur during the transfer, see Chapter "Faults and alarms (Page 333)" for possible
reasons and remedies.
Transferring data from SD card to converter
There are two ways to perform a data transfer.
Method 1:
(Precondition: Converter is to be powered up after inserting the card)
1. Fit the option module to the converter.
2. Insert the card into the option module. Make sure the card contains the file "clone00.bin".
3. Power on the converter.
Data transfer starts automatically. Then the fault code F395 displays which means
"Cloning has occurred. Do you want to keep the clone edits?".
4. To save the clone edits, press
written to EEPROM, the LED is lit up orange and flashes at 1Hz.
If you do not wish to keep the clone edits, remove the card or the option module and
restart the converter. The converter will power up with the fault code F395 (r0949 = 10)
indicating that the previous cloning was aborted. To clear the fault code, press
Method 2:
(Precondition: Converter is powered up before inserting the card)
1. Fit the option module to the powered converter.
2. Insert the card into the option module.
3. Set P0003 (user access level) = 3.
4. Set P0010 (commissioning parameter) = 30.
5. Set P0804 (select clone file). This step is necessary only when the card does not contain
the file "clone00.bin". The converter copies by default the file "clone00.bin" from the card.
6. Set P0803 (transfer data from card to converter) = 2 or 3.
The converter displays "8 8 8 8 8" during transfer and the LED is lit up orange and flashes at
1 Hz. After a successful transfer, both P0010 and P0803 are automatically reset to 0.
Note that fault code F395 only occurs with power-up cloning.
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
and the fault code is cleared. When the clone file is
Options and spare parts
B.1 Options
.
361