Siemens SINAMICS V20 Operating Instructions Manual page 71

Parameter Description
P0771[0] CI: Analog output
P0731[0] BI: Function of digital output 1
P0732[0] BI: Function of digital output 2
Connection macro Cn003 - Fixed speeds
Three fixed speeds with ON/OFF1
If more than one fixed frequency is selected at the same time, the selected frequencies are
summed, that is, FF1 + FF2 + FF3.
Connection macro settings:
Parameter Description
P0700[0] Selection of command source
P1000[0] Selection of frequency
P0701[0] Function of digital input 1
P0702[0] Function of digital input 2
P0703[0] Function of digital input 3
P0704[0] Function of digital input 4
P1016[0] Fixed frequency mode
P1020[0] BI: Fixed frequency selection bit 0
P1021[0] BI: Fixed frequency selection bit 1
P1022[0] BI: Fixed frequency selection bit 2
P1001[0] Fixed frequency 1
P1002[0] Fixed frequency 2
P1003[0] Fixed frequency 3
P0771[0] CI: Analog output
P0731[0] BI: Function of digital output 1
P0732[0] BI: Function of digital output 2
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
Factory default Default for Cn002
21 21
52.3 52.2
52.7 52.3
Factory default
1
1
0
0
9
15
1
722.3
722.4
722.5
10
15
25
21
52.3
52.7
Commissioning via the built-in BOP
5.5 Quick commissioning
Remarks
Actual frequency
Converter running
Converter fault active
Default for Cn003 Remarks
2 Terminal as command source
3 Fixed frequency
1 ON/OFF
15 Fixed speed bit 0
16 Fixed speed bit 1
17 Fixed speed bit 2
1 Direct selection mode
722.1 DI2
722.2 DI3
722.3 DI4
10 Speed low
15 Speed middle
25 Speed high
21 Actual frequency
52.2 Converter running
52.3 Converter fault active
69