Siemens SINAMICS V20 Operating Instructions Manual page 355

The SINAMICS V20 product series and SINAMICS V20 Smart Access comply with the require-
ments of the Korean Certification (KC mark).
The SINAMICS V20 series (FSAA, FSAB, FSAC, and FSAD excluded) has been defined as Class
A equipment, which is intended for industrial applications and has not been considered for home
use. The SINAMICS V20 FSAA, FSAB, FSAC, and FSAD products have been defined as Class B
equipment, which are intended for both industrial applications and home use with additional EMC
measures.
EMC limit values in South Korea
The EMC limit values to be complied with for South Korea correspond to the limit values of the
EMC product standard for variable-speed electric drives EN 61800-3, Category C2 or limit value
class A, Group 1 according to EN55011. By applying suitable supplementary measures, the limit
values according to Category C2 or according to limit value class A, Group 1are maintained. Fur-
ther, additional measures may be required, for instance, using an additional radio interference
suppression filter (EMC filter). The measures for EMC-compliant design of the system are de-
scribed in detail in this manual.
Please note that the final statement on compliance with the standard is given by the respective
label attached to the individual unit.
Notice to users in South Korea:
이 컴퓨터는 전자파 적합성평가(인증)를 받은 내장구성품을 사용하여 조립한것으로 완성품에 대한
전자파 적합성평가는 받지 않은 제품입니다.
ISO 9001 Siemens AG uses a quality management system that meets the requirements of ISO 9001.
SINAMICS V20 Smart Access complies with the appropriate FCC standard.
FCC compliance statement
SINAMICS V20 Smart Access complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause un-
desired operation.
Changes or modifications made to this device not expressly approved by SIEMENS may void the
FCC authorization to operate this device.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
•
•
•
RF exposure statement
This equipment complies with radio frequency exposure limits set forth by the FCC for an uncon-
trolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the
device and the user or bystanders.
This device must not be co-located or
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
operating in conjunction with any other antenna or transmitter.
Technical specifications
353