Siemens SINAMICS V20 Operating Instructions Manual page 286

Parameter list
8.2 Parameter list
Parameter Function
MODBUS on RS485:
Index: [0]
[1]
...
[7]
Note: Restrictions:
If the above serial interface controls the converter (P0700 or P0719) then the 1st control word must be
•
transferred in the 1st PZD-word.
If the setpoint source is selected via P1000 or P0719, then the main setpoint must be transferred in the
•
2nd PZD-word.
When P2012 is greater than or equal to 4 the additional control word (2nd control word) must trans-
•
ferred in the 4th PZD-word, if the above serial interface controls the converter (P0700 or P0719).
284
Range Factory
default
Received word 0
Received word 1
...
Received word 7
Can be Scaling Data
changed set
Operating Instructions, 10/2019, A5E34559884-012
Data Acc.
type Level
SINAMICS V20 Converter