Siemens SINAMICS V20 Operating Instructions Manual page 329

Parameter Function
0
1
2
3
Index: [0]
[1]
[2]
Note: When the value of P3350 is changed, the value of P3353 is changed as follows:
P3350 = 2: P3353 = 0.0s
•
P3350 ≠ 2: P3353 = default
•
The ramp time of 0s gives an additional 'kicking' effect when hammer start is in use.
This setting can be overridden by the operator.
If blockage clearing mode is enabled (P3350 = 3), make sure that reverse direction is not inhibited, i.e.
P1032 = P1110 = 0.
P3351[0...2] BI: Super torque enable
Defines source of the super torque enable when P3352 = 2.
Dependency: Applies only when P3352 = 2.
P3352[0...2]
Super torque startup mode
Defines when the super torque function becomes active.
0
1
2
Index: See P3350
Dependency: If P3352 = 2, enable source is defined by P3351
P3353[0...2] Super torque ramp time [s]
Defines the ramp time to be used for all super torque functions. Overrides the P1120/P1060 when convert-
er is ramping to super torque/hammer start frequency (P3354) or the blockage clearing frequency (P3361).
Index: See P3350
Dependency: The value of this parameter is changed by the setting of P3350.
See the description of P3350.
P3354[0...2] Super torque frequency
[Hz]
Defines the frequency at which the additional boost is applied for super torque and hammer start modes.
Index: See P3350
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
Range Factory
default
Super torque modes disabled
Super torque enabled
Hammer start enabled
Blockage clearing enabled
Drive data set 0 (DDS0)
Drive data set 1 (DDS1)
Drive data set 2 (DDS2)
0 - 4294967295 0
0 - 2 1
Enabled on first run after power-up
Enabled on every run
Enabled by digital input
0.0 - 650.0 5.0
0.0 - 550.0 5.0
Can be Scaling Data
changed set
T - CDS
T - -
T - -
T - -
Parameter list
8.2 Parameter list
Data Acc.
type Level
U32 2
U16 2
Float 2
Float 2
327