Lighting Lever Switch - MG RX8 Manual

Lighting Lever Switch

Take care not to dazzle oncoming vehicles
when switching
headlamps and dipped beam headlamps.
2
3
4
1
Direction Indicators
Move the lever down to indicate a LEFT turn (1). Move the
lever up to indicate a Right turn (2). The corresponding
Instruments and Controls
between main beam
GREEN indicator lamp in the instrument pack will flash
when the turn signal lamps are working.
After resetting the steering wheel, the lever will be
automatically reset, and the turn signal lamps go off. But
if the steering wheel angle is small, manually reset the
lever to turn off the turn signal lamps. If the lever angle
is small, it will be reset immediately. And the turn signal
lamps and direction indicators flash three times and then
automatically go off.
Main/Dipped Beam Headlamps Switching
With the ignition switch in ON position and the master
light switch turned to position 3, push the lever (3) towards
the instrument panel to operate main beams, and the main
beam indicator in the instrument pack illuminates. Push the
lever (3) once again to switch to dipped beam headlamps.
Main Beam Flash
To briefly flash the main beam on and off, pull the lever (4)
towards the steering wheel and then release.
1
41