Switch Off/Re-Start; Figure 29: Switch Off/Restart Of The I/O-Ipc - WAGO -I/O-IPC-C6 Manual

64 Commissioning
Pos: 41.9 /Serie 758 (Funk, IPC und PFC)/In Betrieb nehmen/In Betrieb nehmen 758-87x 6 -Überschrift @ 11\mod_1315222738358_21.doc @ 78221 @ 2 @ 1
8.5

Switch Off/Re-start

Pos: 41.10 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitshinweise/Sicherheitshinweise 758-87x Heiße Oberseite PIKTOGRAMM @ 10\mod_1315199932690_21.doc @ 78103 @ @ 1
Hot surface!
The I/O-IPC housing may become hot during operation. If the I/O-IPC has been
in operation, allow it to cool off before moving it.
Pos: 41.11 /Serie 758 (Funk, IPC und PFC)/In Betrieb nehmen/In Betrieb nehmen 758-87x 6 Text ohne FB @ 11\mod_1315225690002_21.doc @ 78253 @ @ 1
To switch the I/O-IPC off, proceed as follows:
1. Close the running software and the operating system.
2. Switch the I/O-IPC off by turning off the power supply or by disconnecting
the power socket from theX4 connector (9).
To restart the I/O-IPC, press the reset button (45) or switch the I/O-IPC off and
then on again.
Pos: 41.12 /Serie 758 (Funk, IPC und PFC)/In Betrieb nehmen/In Betrieb nehmen 758-87x - ohne FB Bild @ 10\mod_1313398767865_21.doc @ 76874 @ @ 1
9

Figure 29: Switch off/restart of the I/O-IPC

Pos: 42 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
CAUTION
Run
Stop
RST
45
WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Manual
Version 2.3.0