Switch Off/Re-Start; Figure 25: Switch Off/Restart Of The I/O-Ipc - WAGO -I/O-SYSTEM 750 User Manual

58 I/O-IPC Start-Up
8.5

Switch Off/Re-start

Hot surface!
The I/O-IPC housing may become hot during operation. If the I/O-IPC has been
in operation, allow it to cool off before moving it.
To switch the I/O-IPC off, proceed as follows:
1. Close the running software and the operating system.
2. Switch the I/O-IPC off by turning off the power supply or by disconnecting
the power socket from theX4 connector (10).
To restart the I/O-IPC, press the reset button (45) or switch the I/O-IPC off and
then on again.
10

Figure 25: Switch off/restart of the I/O-IPC

CAUTION
Run
Stop
RST
45
WAGO-I/O-SYSTEM 750
I/O-IPC-C10E, CANopen Master