Power Supply Via 750-626 Filter Module; Table 22: Connection For Electronic Supply: Terminal Layout - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Pos: 38.11 /Serie 758 (Funk, IPC und PFC)/Anschluss Daten- und Versorgungskabel/Anschluss Daten- und Versorgungskabel 758-87x 750-626 - Überschrift 2 @ 10\mod_1313497552539_21.doc @ 77103 @ 2 @ 1
7.4

Power supply via 750-626 Filter Module

Pos: 38.12 /Serie 758 (Funk, IPC und PFC)/Anschluss Daten- und Versorgungskabel/Anschluss Daten- und Versorgungskabel 758-87x Einleitung 750-626 @ 10\mod_1313497568008_21.doc @ 77109 @ @ 1
The 750-626 Filter Module is required as soon as a supply line exceeds 3 m
between the voltage source and the I/O-IPC.
Pos: 38.13 /Serie 758 (Funk, IPC und PFC)/Anschluss Daten- und Versorgungskabel/Anschluss Daten- und Versorgungskabel 758-87x 750-626 Einleitungsende @ 10\mod_1312442131062_21.doc @ 75871 @ @ 1
Observe current carrying capacity!
For this power supply variant, you will need the 750-626 Filter Module starting
with hardware version 4. This is the only filter module configured for the higher
current carrying capacity. You can obtain the filter module from www.wago.com.
Observe the isolation voltage!
When using the 750-626 Filter Module, the isolation voltage of the field and
electronic power supply is reduced to 50 V against ground.
Ensure the correct conductor cross-sectional area!
Use conductor cross-sectionsranging from 0.08 mm² to 2.5 mm² (28 - 14 AWG)
only for the CAGE-CLAMP
Requirements for connecting the supply voltage
You have connected two supply lines each to two voltage sources of
•
+24 V DC and 0 V DC in a de-energized state.
You have connected the accompanying socket for the X4 connection to the
•
supply cable.

Table 22: Connection for Electronic Supply: Terminal Layout

X4 connector
3
Pos: 38.14 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 2.3.0
®
Pin
1
2
1
2
3
Connecting the Supply Voltage
connections of the filter module.
Description
V_IN (+)
GND (-)
Shield (optional)
51