Dismounting The I/O-Ipc; Disconnecting Cables And Conductors; Figure 15: I/O-Ipc Interfaces - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Pos: 36.17 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x allgemein 1 @ 10\mod_1312439787258_21.doc @ 75849 @ 2 @ 1
6.6

Dismounting the I/O-IPC

To replace an I/O-IPC (e.g., in the event of version change), proceed as described
in the following section.
Pos: 36.18 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Sicherheitshinweise/Sicherheitshinweise 758-87x Heiße Oberseite PIKTOGRAMM @ 10\mod_1315199932690_21.doc @ 78103 @ @ 1
Hot surface!
The I/O-IPC housing may become hot during operation. If the I/O-IPC has been
in operation, allow it to cool off before moving it.
Pos: 36.19 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x Handlung allgemein @ 10\mod_1315199590906_21.doc @ 78100 @ 3 @ 1
6.6.1

Disconnecting Cables and Conductors

To remove the cables and conductors, proceed as follows:
1. Disconnect from the power supply those parts of the system on which you
have mounted the I/O-IPC.
2. Disconnect the plugs/sockets from the I/O-IPC interfaces and remove the
data cables.
3 Remove the conductors from the first 750 Series I/O Module connected to
the I/O-IPC (A).
Pos: 36.20 /Serie 758 (Funk, IPC und PFC)/Montieren/Demontage 758-87x ohne FB - Bild 1 @ 10\mod_1313398206839_21.doc @ 76858 @ @ 1

Figure 15: I/O-IPC interfaces

Pos: 36.21 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 2.3.0
CAUTION
Run
Stop
Installing and Removing the I/O-IPC 43
A
...