Commissioning; Configuration And Parameterization With Wago Software Tools; Start Via Wago-I/O-Check; Figure 13: Starting The Parameterization Dialog From Wago-I/O-Check - WAGO 750 XTR Manual

58

Commissioning

7 Commissioning
7.1 Configuration and Parameterization with
WAGO Software Tools
7.1.1

Start via WAGO-I/O-CHECK

The I/O module is supported by the commissioning tool WAGO-I/O-CHECK as of
version 03.24.05(01).

Figure 13: Starting the Parameterization Dialog From WAGO-I/O-CHECK

To start parameterizing the I / O module using the WAGO-I/O-CHECK
commissioning tool, proceed as follows:
Requirements:
• The node is connected to the computer.
•
WAGO-I/O-CHECK is open.
• Communication settings are made.
⇨ The node configuration is determined and the node structure is shown in
1. Left-click on the menu item [Identify].
the overview area.
⇨ The I/O module is marked with a frame.
2. Select the I/O module.
3. Right-click to open the context menu and select the Settings menu item.
Manual
Version 1.0.2
WAGO I/O System 750 XTR
750-471/040-000 4AI U/I Diff Galv XTR