Web-Based Management (Wbm); Figure 30: Entering The Authentication - WAGO -I/O-IPC-C6 Manual

66 Configuration
9.1

Web-Based Management (WBM)

The implemented HTML pages (abbreviated as "pages" in the following) for
Web-Based Management are used to configure the I/O-IPC. To access Web-
Based Management, proceed as follows:
Pos: 44.2 /Serie 758 (Funk, IPC und PFC)/Konfigurieren/Konfigurieren 785-87x 2 @ 11\mod_1315226371364_21.doc @ 78257 @ @ 1
1. Connect the I/O-IPC via the X9 ETHERNET interface to the ETHERNET
network.
Pos: 44.3 /Serie 758 (Funk, IPC und PFC)/Konfigurieren/Konfigurieren 758-87x - allgemein 3 @ 12\mod_1333015164786_21.doc @ 92610 @ 333333333 @ 1
2. To access the pages, start your internet browser and enter the preset IP
address 192.168.2.17 in the address bar. Note that the PC and I/O-IPC must
be on the same subnet for this (see chapter "Setting Up an IP Address").
If you have installed a BootP server on your PC and would like to access WBM
through BootP, use the other interface. You can find detailed information about
this in the chapter "Assigning an IP Address Using BootP".
Hinweis
Start page of the I/O-IPC
If the I/O-IPC does not display the start page, make sure that your internet
browser settings allow the circumvention of the proxy server for local
addresses. Also check whether your PC is located in the same subnet as the
I/O-IPC.
Some WBM pages are password protected. The first time you select an item from
the navigation bar, the password query appears:

Figure 30: Entering the authentication

WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Manual
Version 2.3.0