WAGO -I/O-IPC-C6 Manual page 218

218 Appendix
Table 121: Description of the configuration scripts for "TCP/IP"
Parameter
DNS Server 1
DNS Server 2-n
Add DNS Server write
TCP/IP Configuration Eth0
State
Device ID Eth0
State Eth0
Status Call
read get_dns_server 1
edit_dns_server
write/ dns-server-nr=1
change=change
change
dns-server-name=<value>
edit_dns_server
write/
dns-server-nr=1
delete
delete=delete
See "DNS Server" 1. When calling, adjust the server number
(count up)
edit_dns_server add=add
dns-server-name=<value>
get_eth_config
read
eth0 device-id
get_eth_config
read
eth0 state
config_interfaces
interface=eth0
write
config-type=static
state=enabled
WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Output/Input
DNS server address with
the consecutive number 1.
Set the address of the DNS
server with the consecutive
number 1.
The <value> is an IP
address in the format
number.number.number.
number.
Delete the DNS server with
the consecutive number 1.
Add additional DNS
addresses here.
The <value> is an IP
address in the format
number.number.number.
number.
Device ID of the
ETHERNET interface:
X8
X9
Status of the ETHERNET
interface Eth0:
enabled
disabled
Switch off interface:
disabled
When switching on, always
specify the config type.
Validity
immediate
immediate
immediate
immediate
Manual
Version 2.3.0