Usb Interfaces (X10, X11); Figure 9: Usb Interface; Table 16: Usb Interfaces: Pin Assignments - WAGO -I/O-IPC-C6 Manual

34 Description of I/O-IPC Interfaces
5.4

USB Interfaces (X10, X11)

The USB interfaces are used to connect USB devices such as USB memory. If the
connected USB device is not used, you can remove it at any time. If a USB
memory is connected, it is important to remember to close any open files before
removing the USB memory.
The following table provides information on the USB interface pin assignments:

Table 16: USB Interfaces: Pin Assignments

Connector
4 2 1
3
Figure 9: USB
Interface
Pin Description
1 USB_VCC1
2 USB_N1
3 USB_P1
4 USB_GND
WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Manual
Version 2.3.0