Ethernet" Page; Ntp" Page; Table 31: Description Of The Parameters Of The "Ethernet" Page; Table 32: Description Of The Parameters Of The "Ntp" Page - WAGO -I/O-IPC-C6 Manual

WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
9.1.5

"ETHERNET" Page

Configure the transmission speed and communication method of the I/O-IPC
ETHERNET interface on this page. To accept your entries, click on the
[SUBMIT] button.

Table 31: Description of the Parameters of the "ETHERNET" Page

Transmission Mode Eth0 und Eth1
Autonegotiation on
Settings
9.1.6

"NTP" Page

On this page, configure the NTP parameters for setting the time clock. To accept
your entries, click on the [SUBMIT] button.

Table 32: Description of the Parameters of the "NTP" Page

Configuration Data
Enabled
Disabled
Port
Time Server
Update Time (sec)
Manual
Version 2.3.0
When the function is enabled, two ETHERNET interfaces (e.g.
from a computer and I/O-IPC) connected to each other establish
the maximum possible transmission speed and the duplex
method together independently.
Select the fixed transmission speed and communication method:
10 Bit or 100 Mbit half-duplex
(Half-duplex: Information can be send or received)
10 MBit or 100 Mbit full-duplex
(Full-duplex: Information can be sent and received
simultaneously)
Activate/deactivate time update here.
Here, enter the port number for the NTP access (base setting:
123)
Enter the IP address of the time server here.
Set the cycle time here to specify how often the time should be
requested from the time server.
Configuration 71