WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Pos: 50 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Diagnose - Service/Diagnose - Überschrift 1 @ 4\mod_1240831069471_21.doc @ 31372 @ 1 @ 1
14
Diagnostics
Pos: 51.1 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose LED-Signalisierung 758-87x allgemein @ 10\mod_1312534609600_21.doc @ 76001 @ 2 @ 1
14.1
Operational Messages
All operational messages of the I/O-IPC are described in the table below. These
messages are indicated by LEDs:
Pos: 51.2 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose LED-Signalisierung 758-87x ohne FB - Bild @ 10\mod_1313399438688_21.doc @ 76887 @ @ 1
Figure 74: Identification of LEDs
Pos: 51.3 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose LED-Signalisierung 758-87x Tabelle allgemein 1 @ 10\mod_1313038907721_21.doc @ 76398 @ @ 1
Table 61: I/O-IPC Operational Messages
Position
30/32
31/33
35
36
Manual
Version 2.3.0
31
30
32 33
Run
Stop
RST
LED
Color/Status
ACT/LNK
OFF
Yellow
Yellow flashing
Speed
Green
OFF
U2
Green, red,
yellow, off,
U1
Green, red,
yellow, off
40 41
38 39
37
36
35
Cause
I/O-IPC has no
connection to the
ETHERNET network
Connection to the
ETHERNET network is
available.
Data is being
exchanged over
ETHERNET network.
Transmission speed
100 Mbit/s
Transmission speed
10 Mbit/s
-
-
Diagnostics
161
42
43
44
A
A
C
C
B
B
D
D
Explanation/Remedy
Check the cables for
ETHERNET interfaces
X8/X9.
-
-
Transmission speed is
defined by the
ETHERNET network
participants.
LED that can be freely
programmed by the user
(using MiscLib.lib).
LED that can be freely
programmed by the user
(using MiscLib.lib).