WAGO Kontakttechnik GmbH & Co. KG declines all liability resulting from improper action and damage to WAGO products and third party products due to non-observance of the information contained in this manual.
More information References on additional literature, manuals, data sheets and internet pages. 1.3 Number Notation Number Code Example Note Decimal normal notation Hexadecimal 0x64 C notation Binary '100' within inverted commas, '0110.0100' nibble separated with dots WAGO-I/O-SYSTEM 750 I/O Modules...
Do not use any contact spray. The spray may impair the functioning of the contact area. The WAGO-I/O-SYSTEM 750 and its components are an open system. It must only be assembled in housings, cabinets or in electrical operation rooms. Access must only be given via a key or tool to authorized qualified personnel.
Error AI 4 E1 E2 Datacontacts AI 1 AI 2 Common Common (ground) (ground) E3 E4 AI 3 AI 4 Common Common (ground) (ground) 750-455 Power jumper contacts Fig. 2.1.1-1: 4-Channel Analog Input Module 750-455 g045500e WAGO-I/O-SYSTEM 750 I/O Modules...
However, if such a case should occur, another supply module must be added. The analog input module 750-455 can be used with all couplers/controllers of the WAGO-I/O-SYSTEM 750 (except for the economy types 750-320, -323, -324 and -327). WAGO-I/O-SYSTEM 750...
AI 4 of the admissible measuring range 2.1.1.5 Schematic Diagram AI 1 AI 2 Logic Common (ground) Error 270pF AI 3 AI 4 10nF Common Common (ground) (ground) Fig. 2.1.1-3: 4-Channel Analog Input Module 750-455 g045501e WAGO-I/O-SYSTEM 750 I/O Modules...
EMC-Immunity to interference (CE) acc. to EN 50082-2 (96) EMC-Emission of interference (CE) acc. to EN 50081-1 (93) EMC-Immunity to interference acc. to Germanischer Lloyd (01) (Ship building) EMC-Emission of interference acc. to Germanischer Lloyd (01) (Ship building) WAGO-I/O-SYSTEM 750 I/O Modules...
Page 11
II 3 G EEx nA II T4 Conformity Marking More Information Detailed references to the approvals are listed in the document "Overview Approvals WAGO-I/O-SYSTEM 750", which you can find on the CD ROM ELECTRONICC Tools and Docs (Item-No.: 0888-0412) or in the internet under: www.wago.com...
Some fieldbus systems can process input channel status information by means of a status byte. This status byte can be displayed using the starting tool WAGO-I/O-CHECK 2. However, the coupler / controller process operation is optional, which means that accessing or parsing the status information depends on the fieldbus system.