Error Messages Via I/O-Led; Figure 75: Display Of Blink Codes By The I/O-Led - WAGO -I/O-IPC-C6 Manual

164 Diagnostics
Pos: 51.9 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose I/O-LED 758-87x - Überschrift 2 @ 11\mod_1315485558070_21.doc @ 78956 @ 2 @ 1
14.2

Error Messages via I/O-LED

Pos: 51.10 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose I/O-LED 758-87x Einleitung @ 11\mod_1315485565836_21.doc @ 78969 @ @ 1
This section describes I/O LED (38) in details.
Pos: 51.11 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose I/O-LED 758-87x allgemein @ 10\mod_1312535406181_21.doc @ 76014 @ @ 1
It shows diagnostic messages of the I/O-IPC as a blink code. The number of blink
pulses indicates the error code and error argument. See the following sections.
If there are several error messages, the first message to occur chronologically
always blinks until it is corrected. Only then will any subsequent error message be
displayed.
Pos: 51.12 /Serie 758 (Funk, IPC und PFC)/Diagnose/Diagnose I/O-LED 758-87x ohne FB - Bild @ 10\mod_1313399433563_21.doc @ 76883 @ @ 1

Figure 75: Display of blink codes by the I/O-LED

Pos: 51.13 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Run
Stop
RST
WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
38
A
B
A
C C
B
D D
Manual
Version 2.3.0