Online Mode; Reading Iparameters From The Module Or Parameter File; Figure 25: Start View Of Wago Safety Editor - WAGO 750 Manual

WAGO I/O System 750
753-661/000-004 4FDI 24V PROFIsafe
Depending on the call option, WAGO Safety Editor is started in either ONLINE or
OFFLINE mode.

Figure 25: Start View of WAGO Safety Editor

7.3.1

ONLINE Mode

ONLINE mode is used to change the iParameter settings of an F I/O module
directly.
7.3.1.1

Reading iParameters from the Module or Parameter File

When WAGO Safety Editor is launched, the current iParameter set of the F I/O
module is read from permanent memory of the F I/O module and displayed in the
Input column of the iParameter set table in the Safety Editor.
To access existing parameter files, click the [Open] button in the WAGO Safety
Editor toolbar.
In the Open WAGO iParameter Set dialog, select the folder from which the file is
to be loaded and enter a name for the parameter file. To load this file from the
specified location, click the [Open] button.
Version 1.0.0, valid from HW/SW Version 01/01
Commissioning 55
Manual