WAGO -I/O-IPC-C6 Manual page 75

WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
Table 35: Description of the Screensaver and Cleanmode parameters on the "HMI Settings" page
Cleanmode
Actual State
Timeout (sec)
VGA-Configuration
Select the graphic resolution for the DVI-I interface for the monitor used here. To accept your
entries, click on the [SUBMIT] button. If a dark image is displayed on the monitor/touch screen
only, the resolution selected does not match the resolution of the monitor/touch screen. Choose
another resolution.
Show mouse pointer
Manual
Version 2.3.0
Indicates whether Cleanmode is currently active or inactive
active: green check and text "on"
inactive red cross and text "off"
When Cleanmode is active, contacts of the touch screen are ignored.
Cleanmode can be switched off by the user; at the latest, it is automatically
turned off (and the touch screen is then usable again) following the set
timeout time.
The current value is queried and indicated cyclically every two seconds on
the web site (this is only queried once in Configtool instead of cyclically).
The display can be switched on or off using the [Switch on] or [Switch
off] buttons. These changes are effective immediately.
This indicates the Timeout time for the Cleanmode, i.e. the time, during
which contacts of the touch screen are ignored due to activated
Cleanmode.
You can change the wait time by changing the value in the input field and
clicking on the [Change] button.
The changes immediately effect the next activation of Cleanmode (but not
the already activated Cleanmode).
This is how you can hide or show the mouse pointer on the monitor.
Configuration 75