Figure 14: Connecting An I/O Module To The I/O-Ipc Connecting Clamp - WAGO -I/O-IPC-C6 Manual

42 Installing and Removing the I/O-IPC
To connect the I/O modules, proceed as described below:
1. Disconnect from the power supply those parts of the system on which you
wish to mount the I/O-IPC.
2. Insert the slot (71) of each I/O module onto the key (70) of the previous
module.
Electric voltage!
When using 120/230V I/O modules, observe the safety precautions in the
accompanying manual. If these precautions are not observed, there is a danger of
electrical shock.
The highest current carrying capacity of the power contacts is 10A!
The maximum current carrying capacity of the I/O module power contacts must
not exceed 10 A. An increase in current can lead to overheating of the contacts
and damage to the I/O modules.
3. Connect the end module as the last.
When another I/O module is snapped on, the supply voltage for the sensors and
actuators is automatically conducted over the power jumper contacts. The
prerequisite is that the I/O modules used must also have power jumper contacts.
Pos: 36.15 /Serie 758 (Funk, IPC und PFC)/Montieren/Montage 758-87x ohne FB - Bild 3 @ 10\mod_1313398287746_21.doc @ 76870 @ @ 1

Figure 14: Connecting an I/O module to the I/O-IPC connecting clamp

Pos: 36.16 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
758-874/000-110 WAGO-I/O-IPC-C6
71
70
70
71
Manual
Version 2.3.0