Thermosensor; Water Temperature Sensor - KYMCO X -Town 125 ABS Service Manual

12. COOLING SYSTEM
WATER TEMPERATURE
SENSOR
REMOVAL
Remove the luggage box
Drain the coolant
Disconnect the water temperature sensor
connectors (1).
Remove the water temperature sensor (2)
from thermostat.
INSPECTION
Connect the water temperature sensor to the
ohmmeter and dip it in water contained in a
pan which is placed on an electric heater.
Gradually raise oil temperature while
reading the thermometer in the pan and the
ohmmeter connected. If the resistance
measured is out of specification, replace the
temperature gauge with a new one.
Temperature
50ºC
100ºC
＊
● Handle the water temperature sensor
carefully as it is vulnerable to impact.
● Do not allow the water temperature
sensor and the thermometer to come in
contact with the bottom of the pan.
12-17
Standard resistance
133.9--178.9 Ω
26--29.3 Ω

Thermosensor

Thermometer
INSTALLATION
Tighten the water temperature sensor.
Torque: 0.8 kgf-m (8 N-m, 5.8 lbf-ft)
Connect the sensor connectors.
After the water temperature sensor has been
installed, fill coolant and perform air
bleeding .
X -Town 125 ABS/ CBS