Wts Sensor - KYMCO People GT 200i Service Manual

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

13. FUEL INJECTION SYSTEM
People GT 200i
MAP Sensor
Throttle Body
ISC
WTS SENSOR (Water
Temperature Sensor)
REMOVAL / INSTALLATION
Drain the coolant from the cooling system.
Disconnect the WTS sensor connector from
TPS
the sensor.
Remove the WTS sensor and O-ring.
Injector
Install a new O-ring and WTS sensor.
Always replace an O-ring with a new one.
Tighten the WTS sensor to the specified
torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill
the
cooling
system
with
the
recommended coolant.
O-ring
INSPECTION
Measure the resistance at the WTS sensor
terminals.
STANDARD
ºC
-20
40
100
KΩ
18.8
1.136
0.1553
13-21

Advertisement

Table of Contents
loading

Table of Contents