1.TROUBLESHOOTING FOR THE HARDWARE
Finisher and Hole punch unit (both optional)
Separate the Finisher from the equipment.
1
1. Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
When the Hole Punch Unit is not installed
2. Pull the lever to unlock the finisher.
When the Hole Punch Unit is not installed
3. Placing your hands on the positions shown in the figure, move the finisher slowly until it stops, and then open
the front cover of the finisher.
When the Hole Punch Unit is not installed
Remove the misfed paper from the entrance of the finisher.
2
When the Hole Punch Unit is installed
When the Hole Punch Unit is installed
When the Hole Punch Unit is installed
Clearing a Paper Misfeed 33