Table of Contents
Advertisement
2. Take out the lyse container;
3. Remove the container cap and insert the tube end that has no connector into the
container and tighten the cap until properly secured, as Figure 4-6 shows;
4. Locate the orange fitting marked "LYSE" in the lower right corner of the back of the
analyzer;
5. Plug the orange connector of the tube into the fitting and turn it clockwise until properly
secured.
Connect the waste container
1. Take out the waste tube (the one with a red connector) from the accessory box;
2. Locate the red fitting marked "WASTE" in the lower right corner of the back of the
analyzer;
3. Plug the red connector of the tube into the fitting and turn it clockwise until properly
secured;
4. Prepare a container to receive the waste and place it on or below the countertop;
5. Insert the waste tube into the waste container.
Installing Your Analyzer
Figure 4-5 Lyse container
Figure 4-6 Insert the tube into the container
4-8
Advertisement
Table of Contents
