Table of Contents
Advertisement
D
Communication (8ID communication protocol)
D.1 Introduction
The BC-2800 provides two communication protocols. Which protocol to be used depends on
the sample ID digits that can be received by the data management software installed on the
external computer. If the sample ID upper limit to be received is 8 digits, the 8ID
communication protocol should be selected. If the sample ID upper limit to be received is 15
digits, the 15ID communication protocol should be selected.
When installing the analyzer, Mindray authorized personnel will select a
proper communication protocol that matches the data management software
configured.
To adjust the communication protocol of the analyzer, please contact
Mindray customer service department.
The BC-2800 can transmit the sample data and QC data to an external computer (a host)
through its RS-232 serial port. The transmission can be conducted either automatically or
through the command of the operator after the completion of the sample analysis. Based on
the 8ID communication protocol, this section gives detailed discussion about the setup of
transmission parameter, RS-232 serial port and the data transmission format, therefore,
providing detailed information for the software engineers to program and for the user to
conveniently perform transmission.
D-1
Advertisement
Table of Contents
