Table of Contents
Advertisement
4.3 Unpacking
4.3.1 Unpacking and Inspecting the Analyzer
Your analyzer is tested before it is shipped from the factory. International symbols and special
handling instructions tell the carrier how to treat this electronic instrument. When you receive
your analyzer, carefully inspect the carton. If you see any signs of mishandling or damage,
contact Mindray customer service department or your local distributor immediately. When you
are sure the carton is fine, follow the steps below to unpack the analyzer:
Place the carton on the floor upright with the arrows on the side upwards;
Remove the tape and take out the accessory box. Check the accessories against the
packing list. Notify the Mindray customer service department or your local distributor
immediately if you find anything missing;
Open the main box and check the items inside against the packing list. Notify the
Mindray customer service department or your local distributor immediately if you find
anything missing;
Remove the top protective foam, carefully carry out the analyzer from the box and place
it on the countertop.
Remove the foam fixing the sample probe.
Retain the shipping carton and all the packing materials, as they can be
used for packaging if analyzer must be reshipped.
4.3.2 How to move the analyzer
If the carton is intact, you may use a plate and fork-lifter to move the analyzer for a short
distance.
If your analyzer has been used, do the "Empty tubing" procedure and shut it down
before moving it.
For a short - distance moving on a smooth ground, you may use a trolley to facilitate the
transportation.
During the moving process, protect the LCD and the sample probe from excessive force
and from contact with other objects.
Keep the analyzer upright during the moving process. Do not tilt or incline it.
Do your best to minimize the mechanical shock when moving the analyzer. After a
long-distance moving, check and tune the analyzer before using it.
Installing Your Analyzer
4-4
Advertisement
Table of Contents
