Table of Contents
Advertisement
Entering the names of the sender, tester and checker
To enter the name of the person who sent the sample for analysis, enter the name into the
"Sender" box or SELECT the desired name from the "Sender" pull-down list (if there are
previously saved names in the list ) ; to enter the name of the person who is to run (or has run)
the sample, enter the name into the "Tester" box or SELECT the desired name from the
"Tester" pull-down list (if there are previously saved names in the list ) ; to enter the name of
the person who is to review the sample results, enter the name into the "Reviewer" box, or
SELECT the desired name from the "Checker" pull-down list (if there are previously saved
names in the list ) . All the three pull-down lists are capable of saving 30 entered names.
Exit edit
When you have finished entering all the desired sample information, CLICK the "Yes" button
to save the changes and return to the "Count" screen. If you do not want to save the entered
information, CLICK the "No" button to return to the "Count" screen without saving the
changes.
Batch Edit Mode (external keyboard needed)
If your analyzer is configured as Batch edit, you can continuously enter information of a
batch of samples. Follow the steps given below to do so.
Entering Edit
At the "Count" screen, press [F4] and an edit window will pop up, as Figure 6-9 shows.
Follow the instructions to enter the information of the first sample.
Operating Your Analyzer
Figure 6-8 Select department name
6-13
Advertisement
Table of Contents
